**REPORTED** Logic Sensor (Player Above) - Just stop working?

I did not swap blocks near the sensor. But I tested placing blocks around and near the sensor with block swap off, and none of them broke. When I turned block swap on again, and placed blocks near the sensor (not even swapping blocks, just placing them), it almost immediately broke! I think block swapping is the source of the problem, some way or another.
 
I have no idea if this procedure will work for anyone else, but I was having the same trouble and did this to fix it:
Break the adjacent blocks and then the logic sensor, then replace the logic sensor first, and the blocks second (without using block swap - I turned it off temporarily)

I have no Idea if this will work for you all but it seemed to fix it permanently for me.

Hope this helps! (until a better solution is found)
 
Back
Top Bottom