inomanoms
Eye of Cthulhu
I figured out how to make it work with all the blocks actuated. That way if you have a long run, you won't have solid blocks in places for no reason.
Can you get both directions to work with one elevator?
I figured out how to make it work with all the blocks actuated. That way if you have a long run, you won't have solid blocks in places for no reason.
Ask, and you shall receiveCan you get both directions to work with one elevator?
The top switch goes up and the bottom switch goes down. You get craziness if you turn on both switches on at the same time,
I have built the 2.0 version of the lift, however, it still appears to be broken. I suspect I may have made another error somewhere.
Ok, I'll try that. ThanksI'll wait for the video, but maybe try trouble-shooting your problem by digging out this area of blocks:
View attachment 80438
replacing the yellow pressure plates with blue or red ones, and walking over them with the player left to right. That way you can see at least if the wiring is wrong, or if it is the bird that is causing problems.
The redesigned elevator (which it looks like you're using) doesn't need to have blocks solid at the beginning. They should all be actuated.The markers on the right represent every six blocks where the non-actuated blocks are, (although some lower markers are missing)
Ah, I get it now. That sounds like the source of the problem.The redesigned elevator (which it looks like you're using) doesn't need to have blocks solid at the beginning. They should all be actuated.
Ah, I get it now. That sounds like the source of the problem.
The (almost) continuous loop of this design is more forgiving about floor heights than my other designs. And, yeah, when its off the down shaft would just be a big hole in the ground that would need to be plugged.elevator shafts of differing heights, floor heights that are not multiples of 6 blocks
Managed to get it working. Thank you guys so much!
The latest one. With no actuated starting blocks and access to turning on and off.Out of interest which of @Bahamut2001's designs did you use?